Find Hole Flute @ Amazon.com
|
The Chinese bamboo flute, or dizi has a history of over 2000 years. It is a small, commodious pipe that is played horizontally and gives rise to a resonant and clear sound. Dimo or flute membrane is stuck over the dimo hole on the instrument for it to create it is unique, penetrating tone. When played, the sound from the instrument is produced by the vibration of air columns within the bamboo flute. Below is an introduction of the anatomy of the dizi. - There are when it comes to 10 holes on a normal C Key Chinese bamboo flute, dizi. - The 1st hole on the far left of the flute which is a distance away from the rest of the hole, is called the ‘mouth hole’. - You place your lower lip at the edge of the mouth hole, versus the dizi. - Air is blown directly all over the hole. - The hole next to the ‘mouth hole’ is called the ‘membrane hole’, or the ‘mo kong’. - This is where you stick the flute membrane called ‘dimo’ over the hole to construct it is bright and discerned timbre. - Some Chinese bamboo flutes may have copper joints in amidst the ‘mouth hole’ and ‘membrane hole’. - When you twist the copper joint of the dizi outwards, the pitch becomes flat. - On the other hand, when you twist the copper tuning inwards, the pitch becomes sharp. - Twist the dizi isolated rather of pulling as you may harm the copper joint. - After the ‘membrane hole’ comes 6 other holes which are the finger holes. - The last 2 holes at the end of the dizi act as air vents. They affect the overall pitching of the Dizi but you may leave them alone. - If the dizi is in the key of C, covering 3 holes will give you the C note while covering all holes will give you the G note. |
Similar Products To Hole Flute
Hisonic Signature Series 2810N Closed 16-hole Flute
Amana Tool 45650 Key Hole Shank Single Flute Carbide Tipped Router Bit, 1/4-Inch
Mendini MFE-22S Intermediate Open/Closed-Hole Silver Plated C Flute + Case, Chromatic Tuner w/ Metronome, Stand, Pocketbook, Cleaning Rod & Cloth, Joint Grease, & a Pair of Gloves
Mendini MFE-30S Intermediate Open/Closed-Hole Silver Plated C Flute w/ B Foot Joint + Case, Chromatic Tuner w/ Metronome, Stand, Pocketbook, Cleaning Rod & Cloth, Joint Grease, & a Pair of Gloves
Magafor 4143010 414 Series 1 Flute, 82 Degrees Cutting Angle, 1-3/16" Cutting Angle Cobalt Steel Uncoated (Bright) Combination Countersink And Deburring Bit With Hole
The Five-Hole Flute
Magnate C5004 Key Hole Router Bits – 2 Flute; 5/16" Under-Cut; 1/4" Shank Diameter
Magnate S5002 Key Hole Router Bits – 2 Flute; 1/8" Under-Cut; 1/2" Shank Diameter
Magnate 5001 Key Hole Router Bits – 1 Flute; 3/16" Under-Cut; 1/4" Shank Diameter




